ODIN Works 9 mm Atlas Compensator 1/2-36 threads

ODIN Works 9 mm Atlas Compensator 1/2-36 threads

The proper orientation or “timing” of an AR compensator is critical and can be tedious. The unique design of the ODIN Works Atlas Compensator has eliminated the need for crush washers and shimming. The Atlas 9mm Compensator features a 3-piece configuration that consists of the steel core, steel end cap and the Titanium sleeve. Titanium was selected for the sleeve because of its strength and light weight. The cap and the core are manufactured from 416R stainless steel because it’s tough and corrosion resistant. The natural grey color of the Titanium sleeve is accentuated by the Black Nitride finish of the cap and core, giving the set a remarkable 2-Tone look. The combination of reducing recoil and controlling muzzle rise gives this accessory the best of both worlds.

There are 2 thread patterns available for the ODIN Works 9mm Atlas Compensator, 1/2×28 TPI and 1/2×36 TPI. The Atlas Compensator is also available in 6.5 Grendel, 5.56, and .308/7.62 caliber models.

NOTE: 416R is a Crucible brand steel and it was formulated specifically for barrels. Most types of steel, including normal 416SS are not designed to be used in freezing temperatures. But this steel was designed to operate in arctic temperatures, up to -40F. 416R also has greater accuracy potential than normal 416SS and 4150 steel due to its ability to take highly defined rifling and machining cuts.

NOTE: Be SURE to check your AR Barrel threads when you are installing a new comp. It is very easy to cross thread and/or install the wrong compensator, so always double check and be very sure of what you are installing.

Included: 

• Black Nitride Isonited 416R stainless steel cap
• Black Nitride Isonited 416R stainless steel body
• Titanium sleeve with gas ports
• Hex wrench and set screws

Technical Specs:

• 2.5″ inches overall length
• 3.9 ounces total weight
• 1″ inch in diameter
• Designed for 9mm AR builds
• 1/2-36 or 1/2-28 thread pattern available