KAK Retro AR15 Extended Flash Hider 1/2-28 - 6 Inch

Retro AR15 Extended Flash Hider 1/2-28 - 6 Inch

KAK Industries was inspired by and designed retro AR 15 Extended Flash Hider from the XM-177 Moderator. There are many uses, but the primary idea behind this flash hider is to extend a 10.5" barrel to legal non-NFA length (when pinned and welded). This flash hider is a touch on the heavy side, but that stands to reason as it is heavy duty and machined from bar steel. Similar to an A2, it has 5 ports on the top and sides with no gas ports on the bottom. It only requires a 3/4" wrench to install by hand, plus it has a predrilled 0.125" hole in place for anyone who wishes to pin and weld it in place.

Features

• CNC machined from bar steel
• Heat treated for strength
• Phosphate coated to protect from corrosion
• Threaded 1/2-28
• Bore sized for use on both 5.56mm and 9mm barrels
• 6.15" over all length
• 1.0" diameter
• Adds approximately 5.56" to overall length of barrel when pinned and welded.
• .125" hole pre-drilled for pin and weld
• Weight:  9.7oz
• Requires standard .750" wrench for installation