Strike Industries AR-10 Enhanced Lower Parts Kit - SI-AR10-E-LRPLT

Strike Industries AR-10 Enhanced Lower Parts Kit

The Strike Industries AR-10 Enhanced Lower Receiver Parts Less Trigger, Hammer, and Disconnector includes most of the necessary parts to build (or enhance/upgrade) a lower receiver minus the trigger group, pistol grip, and trigger guard for those lowers that don’t have one built-in. This kit includes all the basics you will need to build out a new lower, and it is a perfect pairing with the many styles of SI AR Grips available. Reuse an existing AR trigger group, or pick your own AR trigger you would rather have, and avoid getting stuck with a plain Jane Mil-Spec trigger that will collect dust in a drawer somewhere. However, the hammer and trigger springs, along with pins, are included in the bag. The Strike Industries AR-10 Enhanced Lower Receiver Parts Trigger, Hammer, and Disconnector includes SI signature enhanced lower parts like the bolt catch, magazine release, pivot/takedown pin,s and HEX Selector Switch that offers both a 60 or 90-degree angles 3 in1 combo, no other lower parts kit (LPK) on the market gives you the most bang for your buck.

Features

• Includes SI’s signature Enhanced Lower Parts
• Freedom to pick your own AR trigger group (AR hammer and trigger springs + pins are included)
• Included SI-enhanced components at a cost-effective LPK price
• Perfect pairing with one of the various SI AR Grips available

Includes

• Strike AR-10 Enhanced Bolt Catch – features improved grip surfaces and angles
• Strike Magazine Catch
• Strike Magazine Catch button – features improved grip surface
• SI Extended Pivot Pin – longer of the two large pins
• SI Extended Takedown Pin – smaller of the two large pins
• HEX Selector Switch – x2 included
• HEX Selector Switch end cap
• HEX Selector Switch 60/90-Degree shaft with screws – x1 shaft and x2 screws
• Bolt Catch Spring – easily confused with the disconnector spring; the disconnector spring is tapered
• Magazine Catch Spring – this is the largest coil spring in the kit
• Pivot Pin Detent Spring – same as the takedown detent spring, so there are two in a kit
• Takedown Pin Detent Spring – same as the pivot detent spring, so there are two in a kit
• Selector Spring – similar to the takedown and pivot detent springs, but with a larger diameter; there will only be one of these
• Buffer Retainer Spring – the second largest coil type spring in the kit
• Hammer Spring – the largest of all the springs
• Trigger Spring – the smaller of the two largest springs
• Disconnector Spring – slightly larger than bolt-catch spring, identifiable because one end is a little bit wider than the other
• Bolt Catch Plunger – mushroom-shaped pin
• Bolt Catch Roll Pin – smaller of the two roll pins
• Pivot Pin Detent – same as takedown detent; both sides usually rounded or semi-conical
• Takedown Pin Detent – same as pivot detent; both sides usually rounded
• Selector Detent – one end is flat, the other pointed/semi-conical
• Buffer Retainer – large hollow barrel with a small pin protruding from the top
• Hammer Pin – solid pin with machined grooves; can be inserted from either side
• Trigger Pin – same as hammer pin; can be inserted from either side