Strike Industries Mass Driver Comp For Glock Gen 5

Strike Industries Mass Driver Comp For Glock Gen 5

The Strike Industries Mass Driver compensator represents a quantum leap in compensator design. Current designs have largely been unchanged since the 1930s. It’s about time for something revolutionary. The Mass Driver name is inspired by the idea of theoretical mass driver engines in space travel. By ejecting mass, an equal and opposite reaction is generated, propelling the space vehicle forward. The Mass Driver Compensator is driven by the hot gases expelled through the barrel after the round is discharged, and acts as a counterbalance system to attenuate mechanical recoil. Barrel-mounted compensators add reciprocating mass and increase the moment of inertia to the operating system, which can have a negative effect on the reliable cycling of recoil-operated handguns. By separating the compensator from the operating components after ignition, the MD comp allows for close to stock cyclic speeds and reduces reciprocating mass.

*Compatible with GEN4 G17 & G19 GLOCK MODELS.

Features

• No threaded barrel needed
• Matches the width of the slide; it can be used with open holsters, no special holster needed
• Counter recoil design, as the slide moves back, the comp moves forward to reduce felt recoil
• Eliminates the need for threaded barrels. 50 State Legal
• Blended, no snag profile
• Precision CNC-machined
• No permanent modification of the weapon is required
• Contours with slide dimensions to be compatible with most open-bottom holsters
• Product Type: Compensator
• Color: Black

Includes

• 1 Comp Main Body
• 1 Recoil Spring
• 1 Guide Rod
• 1 Guide Rod Fitment Washer
• 1 Guide Rod Head
• 1 Internal Spring

Holsters: The Mass Driver Comp sits flush with OEM Glock Slides and can be used in most open-ended holsters that accommodate compensators.

Note: Thread Locker is strongly recommended for all screws. Gunsmith or armorer installation recommended. Product tested with factory GLOCK components. Performance may vary when using third-party GLOCK components. Consult with a local gunsmith for any custom modifications while using this product. Recommended torque value for the guide rod nut is 25 lbs/in. Use with +P and +P+ 9mm ammo will produce premature internal spring wear and cause failure.

DISCLAIMER: “GLOCK” is a federally registered trademark of GLOCK, Inc. and is one of many trademarks owned by GLOCK, Inc. and GLOCK Ges.m.b.H. Neither Rainier Arms LLC, nor this site is affiliated in any manner with, or otherwise endorsed by, GLOCK, Inc. or GLOCK Ges.m.b.H. The use of “GLOCK” on this page is merely to advertise the sale of GLOCK pistols, parts, or components. For additional genuine GLOCK, Inc. and GLOCK Ges.m.b.H products and parts, visit www.glock.com.

DISCLAIMER: This product is not manufactured, authorized, endorsed, or warranted by GLOCK. GLOCK does not warrant or represent that this product is compatible with GLOCK pistols.