KAK Retro AR15 Extended Flash Hider 1/2-28 - 6 Inch - AR15-MD-FH-001
Out of stock
Retro AR15 Extended Flash Hider 1/2-28 – 6 Inch
KAK Industries was inspired by and designed retro AR 15 Extended Flash Hider from the XM-177 Moderator. There are many uses, but the primary idea behind this flash hider is to extend a 10.5″ barrel to legal non-NFA length (when pinned and welded). This flash hider is a touch on the heavy side, but that stands to reason as it is heavy duty and machined from bar steel. Similar to an A2, it has 5 ports on the top and sides with no gas ports on the bottom. It only requires a 3/4″ wrench to install by hand, plus it has a predrilled 0.125″ hole in place for anyone who wishes to pin and weld it in place.
Features:
- CNC machined from bar steel
- Heat treated for strength
- Phosphate coated to protect from corrosion
- Threaded 1/2-28
- Bore sized for use on both 5.56mm and 9mm barrels
- 6.15″ over all length
- 1.0″ diameter
- Adds approximately 5.56″ to overall length of barrel when pinned and welded.
- .125″ hole pre-drilled for pin and weld
- Weight: 9.7oz
- Requires standard .750″ wrench for installation
| Weight | 10 oz |
|---|---|
| Dimensions | 2 × 6 × 8 in |
| Muzzle Device Type | Flash Hider |
| Threads | 1/2×28 |
| Cartridge Compatibility | .22 (.223/5.56/.224, etc.) |
| Finish | Manganese Phosphate |
| MPN | AR15-MD-FH-001 |
| UPC | 15037 |
Compliance
NFA (National Firearms Act) compliance is crucial for legal ownership and transfer of regulated firearms and accessories like short-barreled rifles, suppressors, and certain types of ammunition, ensuring adherence to federal regulations to avoid legal penalties and ensure responsible firearm ownership.
Reviews
There are no reviews yet.